Cement Based, Structural Repair Mortar - REPAMERK 301

Name: Cement Based, Structural Repair Mortar - REPAMERK 301
Brand: Baumerk
Rating: 4.4 (89 reviews)

REPAMERK 301

Description

REPAMERK 301 is a cement based, single component, polymer and fiber reinforced, thixotropic structural repair mortar with high strength. REPAMERK 301 PG is a pouring grade structural repair mortar.

Fields of Application

To repair of the reinforced concrete elements,
To protect concrete against sulphate and chlorine,
To repair and protect underground structures,
Structural and non-structural repairs of high strength concrete elements
To repair light and medium traffic floors,
To repair the tie-rod and cone holes.

Features and Benefits

Non- shrink.
Applicable as 10-40 mm thickness at one layer.
Perfect bonding to the concrete and steel.
High compressive strength.
Does not sag due to the thixotropic behavior.
Waterproof.
Resistant to chloride, sulphate and oils.
Easy to apply, mixed with only water.

Application Procedure

Preparation of Substrate

Concrete surface must be sound, clean and dry. Surface must be clean off dust, dirt, rust, oil and all contaminants. If there is a water leakage, it must be drained or properly plugged. Concrete surfaces must be saturated with water before application. Immediately before pouring, surface should be wetted, then remove all excess or standing water from within any formwork.

Application Method

25 kg REPAMERK 301 is poured into maximum 4 liters of water and mix for 3-4 minutes under low speed mixer until having a homogenous consistency. Let the mortar have rest for 4 minutes and re-mix for 30 seconds. Prepared mortar should be applied within 30 minutes in 20°C. REPAMERK 301 is applied on the surface by using a steel trowel or spray gun. Application thickness should be between 10-40 mm. If needed second coat should be applied after 24 hours in same way. If required more smooth finish, water should be sprayed onto the mortar and the surface should be finished with using steel or wooden trowel. Application surface must be protected from the rain, wind, frost etc. during first 24-48 hours after finishing repair.